This was just to prevent them getting scratched or getting dust on them. I could then use that line as a reference to mark out the rectangle needed to fit the rotary axis in place.īefore cutting out the rectangle I first covered the mirrors and lens of the laser. I used a scrap piece of plywood held against the X gantry to help me mark a straight parallel line. I did this by first marking out where I need to cut. So the first task is to cut a hole in the bottom of the laser case so the rotary axis can sit lower down. It fits in but with a glass on the rotary it is out of focus. The rotary axis is a little tall for the K40 laser engraver. Software Used: Step 1: Cut Space for the Rotary Axis Rotary Axis Use code: BGER816 for 30% OFF.Banggood, very kindly sent me a rotary axis, so in this post I'll show you how I set it up and how I engrave glasses with it. It would allow me to engrave glasses which is something I have done using vinyl templates and sand blasting up until now. I've been wanting to get a rotary axis attachment for my K40 Laser Engraver for a long time now. Introduction: Engraving Glasses With a K40 Laser Another significant addition is dedicated rotary settings and the ability to reduce the rapid speed when using a rotary fixture. The user will need to make sure the scale is correct for their purpose. The big news is that now most SVG files (even if they are made outside of Inkscape) will open in K40 Whisperer. With LightBurn you can: - Import artwork in a variety of common vector graphic and image. Hello guys, Can anyone share with me the software and the key for the K40? LightBurn is layout, editing, and control software for your laser cutter. Wouldn't it be nice if K40 Whisperer plays a sound when the running process is done? Wouldn’t it be nice if K40 Whisperer plays a sound when the running process is done? Software - Jose A.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |